RockShox Pike problem
Marin_B17
Posts: 51
I have 426's and have been unable to fit Avid Juicy 3's on it. I have a 20mm QR mount for the brake calipers. But the pads dont go over the rotor, they are about 2 centimeters off. What should i do? Thanks
0
Comments
-
The pikes are 180mm IS mount, not 160mm so you need an is-pm adaptor and IIRC 180mm minimum size rotor0
-
ye, i have a 203mm rotor and adapor. But the adaptor doesn't fit the fork?!0
-
Then you have the wrong adapter.I don't do smileys.
There is no secret ingredient - Kung Fu Panda
London Calling on Facebook
Parktools0 -
pikes are normally standard IS mount.
not the 20mm version.
Pics of your problem if that does not fix it."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
ride_whenever wrote:The pikes are 180mm IS mount, not 160mm so you need an is-pm adaptor and IIRC 180mm minimum size rotor
Sorry to hijack, but is that correct? I just picked up a set 2nd-hand and didn't bother to even think about that. Info I found on the internet said it was a 6" IS mount which would give 160mm, or have I misunderstood?0 -
Pikes are standard IS mount."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
Forgive the ignorance :roll: , but what is 'standard', 160 or 180?0
-
standard is standard. See the topic in the FAQs.
IS standard is 160/140 F/R"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
-
got the 203 IS bracket and it fits, thanks for the help guys!0
