9.0 gripshift
m1984
Posts: 2
hello. am new to this...only just found it, but looks good. am always after tips and things.
anyways, i got sram 9.0 gripshift on my bike, the problem is the hole unit as started spinning on my bar so its hard to change gear cause everyone follows your hand around. has anyone had this? is there a way of tighting it up?
thank, matt
anyways, i got sram 9.0 gripshift on my bike, the problem is the hole unit as started spinning on my bar so its hard to change gear cause everyone follows your hand around. has anyone had this? is there a way of tighting it up?
thank, matt
0
Comments
-
Hi Matt - welcome to the forum.
On the Gripshifts, follow the line of the transparent window backwards (i.e from 9 --> 1 on the rear shifter, or 1 --> 3 on the front shifter) and as the housing curves under you should find a hole about 6 mm in diameter. Recessed in there is a hex screw for tightening the shifter to the bars.My abundant supply of MTFU is reserved for use in dry, sunny conditions.0
