reba sl
mikef63
Posts: 26
trying to set up the sag on my reba sl dual air forks. followed supersonics instructions as follows:
remove negative air
add positive air until you get desired sag ie about 20 mm. about 80 psi. i weigh 90 kg.
add the same amount of air to negative side.
this is where the problem starts -
as soon as i add any air to the negative side my sag increases, even 5 psi increases the sag.
is there a fault with my forks or am i doing something wrong
remove negative air
add positive air until you get desired sag ie about 20 mm. about 80 psi. i weigh 90 kg.
add the same amount of air to negative side.
this is where the problem starts -
as soon as i add any air to the negative side my sag increases, even 5 psi increases the sag.
is there a fault with my forks or am i doing something wrong
0
Comments
-
Dont you just set it to the pressure in the look-up table for your weight?0
-
followed the sram manual and now have 120 psi pos air and 100 psi neg air and got about 22mm of sag. will leave it like that. contradicts what supersonis said in his help and tips page.0
-
mikef63 wrote:as soon as i add any air to the negative side my sag increases, even 5 psi increases the sag.
is there a fault with my forks or am i doing something wrong
That's what should happen. More pressure means more pull back - that's what tuning is for.0
