Not the usual clipless question - LOOK or SPD?

cheddarpaul
cheddarpaul Posts: 126
edited December 2010 in Road beginners
Hey
I have a set of Look KEO Classic pedals spare but currently ride clipless on both my road and mountain bike

If I was to move to clipped for both bikes (on a budget), any ideas on what would be the best way forward?

A) Should I keep the LOOK pedals and buy new LOOK cleats (£18) then the dhb R1 or M1 shoes from CRC (£50)?

B) Should I get the Shimano M520 from for £20 and cleats (£23) from Wiggle plus either the dhb R1 or M1 shoes from CRC?

C) If I wanted to use one pair of shoes for both road and off-road, would the M1 be the best option?

What else would I need?

Ideally I dont want to spend over £100 if I can help it.....
Boardman Team Comp
Boardman CX Team
Boardman Full Suss Pro
Brick Lane fixie
Genesis Day One

Comments

  • Monty Dog
    Monty Dog Posts: 20,614
    It is the 'usual' clipless question - you just haven't looked hard enough!

    It's all down to convenience and whether you need to walk in your shoes. For most, SPD makes most sense for commuting but realise that you do lose some directness and feeling of positve engagement that you get from road pedals/shoes. For general riding, few would notice.
    Make mine an Italian, with Campagnolo on the side..
  • sheffsimon
    sheffsimon Posts: 1,282
    You are confused about 'clipless', it means without toeclips, and using Look or SPD or whatever, not just flat pedals without any clips.

    I am confused by all your options :) If you arent road racing I would buy two pairs of SPD pedals and a decent pair of stiff soled MTB shoes, much more convienient for commuting also IMO.

    Shimano M520 are good value, use em for cyclocross myself. Cleats comeincluded with them.
  • Thanks for the replies

    I think the best way forward is to get 2 sets of M520s and then a pair of shoes which can be used on both my road and mountain bike

    Looking at the dhb range they seem to get a good write up, either the R1 or the M1

    What is the sizing like on these, I normally wear a 11 / 45??
    Boardman Team Comp
    Boardman CX Team
    Boardman Full Suss Pro
    Brick Lane fixie
    Genesis Day One
  • hammerite
    hammerite Posts: 3,408
    If you're wanting to standardise I'd go for SPD. Not Look, the cleat will get in the way if you do anything remotely techical and need to have a foot out, or do any walking (as SheffSimon would prob agree with CX). You'd be going through cleats in no time.

    The OH uses SPD on all her bikes, and bought a pair of R1. Which while they work in theory with SPD, it's a little more difficult in practise, the cleat is quite discreet, and the shoe sole is very flat slippery. As a result she struggles to clip in quickly/easily. So I'd go for the M1s.