A small question

pikeg123
pikeg123 Posts: 46
edited September 2010 in MTB workshop & tech
Hey guys this may sound a silly question but does anyone know how to fix this problem..

When riding in the bottom 3-4 cogs on the rear the mech its bumping against the frame on almost any bump.. Any idea how i can stop this?

heres a pic

DSCF2748.jpg

Comments

  • Bacon1983
    Bacon1983 Posts: 17
    edited September 2010
    There is a small screw that adjusts the mech's distance from the cogs, it's known as the B-screw. Check ParkTool's website for handy guides of how to adjust your mech.

    P.S. just re-read the question, and I missed the point, but the above might help all the same.
  • chedabob
    chedabob Posts: 1,133
    Think that's something that the B-tension screw can cure. You see that screw on the left near the cassette? Turn it in a few turns. Make a note, because you might have to turn it back if I'm wrong :P
  • cooldad
    cooldad Posts: 32,599
    Chain too long (or using small small combinations?)
    I don't do smileys.

    There is no secret ingredient - Kung Fu Panda

    London Calling on Facebook

    Parktools
  • pikeg123
    pikeg123 Posts: 46
    cheers guys it was the B-Screw after all.. all done

Categories