Horrific crank noise when backpedaling - Fixie

1981.
1981. Posts: 270
edited April 2010 in Road general
Dropped some other wheels onto my fixie (to replace the front and rear that got stolen) and everything seems to be fine. Chainline is straight, and the front ring plus rear sprocket are meshing nicely, even under load.

However - when I apply back pressure to slow the bike, there's a horrendous noise from the front ring/crank, which sounds like the ring chain isn't meshing properly.

Tried everything, from adjusting the rear wheel, to Sheldon's tip of losening off the chainring bolts, tapping, then re-tightening, but it's still there.

The chain is old, would train stretch etc mean the pitch has been worn to the old rear sprocket?

Any help would be very much appreciated.

Cheers,
1981

Comments

  • mf5
    mf5 Posts: 207
    Check the front ring and rear cog for wear, and put some oil on the chain see how it goes. You may need to replace your chain and/or rear cog
  • thel33ter
    thel33ter Posts: 2,684
    I'm no expert on fixies but a new chain and rear cog will probably help, as the chain and cog should wear together for best perfromance. Have you checked if the chainring is worn? because the chain could be jumping forwards due to the pressure being put on it.
    And now you know, and knowing is half the battle
    05 Spesh Enduro Expert
    05 Trek 1000 Custom build
    Speedily Singular Thingy
  • 1981.
    1981. Posts: 270
    Thanks guys - sounds like the chain is shot (rear sprocket is pretty new) - although the chainring is vintage too - so may need to replace the whole shooting match.

    Thanks to the people that stole my wheels, now not only do I need to invest in a new lock – I need to spend money on chain, chainring.

    Arse.
  • mf5
    mf5 Posts: 207
    I lock my wheels, frame everything if I have to leave my bike anywhere- alot to carry in way of locks but its worth it
  • thel33ter
    thel33ter Posts: 2,684
    It's a good excuse to get some blingy fixie bits like coloured chains and anodized chainrings :D so not all bad.
    And now you know, and knowing is half the battle
    05 Spesh Enduro Expert
    05 Trek 1000 Custom build
    Speedily Singular Thingy
  • mf5
    mf5 Posts: 207
    A coloured chain would look quite good on my fixie actually.... where can you get them from?
  • thel33ter
    thel33ter Posts: 2,684
    http://stores.shop.ebay.co.uk/teme-cycl ... mit=Search

    These should fit unless you use an insane gear, like a 60 tooth front ring and 23 rear
    And now you know, and knowing is half the battle
    05 Spesh Enduro Expert
    05 Trek 1000 Custom build
    Speedily Singular Thingy
  • 1981.
    1981. Posts: 270
    mf5 wrote:
    I lock my wheels, frame everything if I have to leave my bike anywhere- alot to carry in way of locks but its worth it

    Yep, learnt that the hard way (I thought for some reason, they wouldn't go for wheels they'd have to undue).

    Crims can use spanners - who knew!
  • 1981.
    1981. Posts: 270
    thel33ter wrote:
    It's a good excuse to get some blingy fixie bits like coloured chains and anodized chainrings :D so not all bad.

    Ha, yes - at least I can spend some money.

    Although coloured chainrings and chains don't really go with the look (first bike in my signature)