Cabling
itboffin
Posts: 20,064
Does anyone know where all those sealed caps and rubber tongue adapters that come with Shimano SP cable sets should be fitted?
I've got dozens of the little buggers and no clue where to fit them if at all.
I've got dozens of the little buggers and no clue where to fit them if at all.
Rule #5 // Harden The Feck Up.
Rule #9 // If you are out riding in bad weather, it means you are a badass. Period.
Rule #12 // The correct number of bikes to own is n+1.
Rule #42 // A bike race shall never be preceded with a swim and/or followed by a run.
Rule #9 // If you are out riding in bad weather, it means you are a badass. Period.
Rule #12 // The correct number of bikes to own is n+1.
Rule #42 // A bike race shall never be preceded with a swim and/or followed by a run.
0
Comments
-
At the end of outers where exposed cables will be. Chainstay and downtube. Are they not intended as some sort of crud seal?Neil
Help I'm Being Oppressed0 -
Yeh but where exactly? I need detailed picturesRule #5 // Harden The Feck Up.
Rule #9 // If you are out riding in bad weather, it means you are a badass. Period.
Rule #12 // The correct number of bikes to own is n+1.
Rule #42 // A bike race shall never be preceded with a swim and/or followed by a run.0 -
Where your cable outers stop at the adjusters on the down tube feed the cable through big hole first then push them over the end of the cable outer. Same at the end of the short bit of cable outer from your rear mech. Big end over cable outer with small end pointing away from the outerNeil
Help I'm Being Oppressed0
