Parts sizes please help

[Deleted User]
[Deleted User] Posts: 0
edited November 2009 in MTB beginners
The user and all related content has been deleted.

Comments

  • nicklouse
    nicklouse Posts: 50,675
    most of the info you need is on On ones site the rest you dont need to wory about.

    BB stanard other than width but it does not really matter as most current set upd fit.

    forks if it was not standard it would say.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • nicklouse
    nicklouse Posts: 50,675
    http://www.on-one-shop.co.uk/?page_id=590
    You’ll need a seatclamp - the seat tube is 29.8mm outside diameter at the top, but clamps labelled 30mm will be fine too. The seat tube butts down to 28.6mm outside at the bottom, for your front mech, and inside the frame takes a 27.2mm seatpost. BB is 68mm shell. Front mech is top pull. Brakes are international standard. Headset is inch and an eighth. All the bits off a standard inbred will fit.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown

Categories