bleeding hope x2
rossi46
Posts: 17
HI,I'm replacing my brake lines with braided ones,I've seen the vid. on the hope web site which says to bleed the brakes without the wheel(just old pads)should I push pistons back before putting the top back on the res.?thanks
0
Comments
-
http://www.youtube.com/watch?v=QzGQpS6fd3E
New video for the tech lever. Not sure if the one on the hope site is for the tech lever.0 -
Brake bleed process is exactly the same for the tech, just need to unclamp the lever clamp bolts and turn the lever vertical with the lever itself under the bars, and then pull the lever a few times to disperse any air caught in the lever reservoir.
You should push the pistons all the way back in before bleeding, and use either old pads or some wood as recommended stops the pistons getting stuck out.0 -
HandjobDan wrote:Brake bleed process is exactly the same for the tech, just need to unclamp the lever clamp bolts and turn the lever vertical with the lever itself under the bars, and then pull the lever a few times to disperse any air caught in the lever reservoir.
So its not exactly the same then
0 -
