Serviced my DMR v12's - but...

lawl

On of them when I went to do the nut up it goes down the threads as far as the other side but doesnt lock tight, its very odd, I wonder if the threads are in trouble

Or is this by design, either way one of them aint right.

Im off to chicksands tomorrow im worried that it will fall off lol

nonnac85

Sounds a bit stupid but have you tried putting the nut on the other way around? On my old cheapo bike some nuts only fitted one way although I think it was the axle ones rather than the pedal.

lawl

Nah mate not tried over way round could try it, I will see if they come loose tomorrow and take a spare set of pedals up

lawl

If not I can replace, ill post links as this post is already listed in google so anyone who has same problem;

nuts;
http://www.chainreactioncycles.com/Mode ... delID=2292

axles;
http://www.chainreactioncycles.com/Mode ... odelID=253

Rockhopper

One side has a left hand thread don't forget.

hucking_fell

With v12s there will still be some sideways play of the pedal body until the cap is replaced over the nut. I stripped a nylock nut before I realised this :oops: