DT Swiss Skewers
TheJackal
Posts: 169
Managed to overtighten and snap the shiny red allen key bolt the other day on my front DT Swiss RWS skewer.
The lever then fell off but the ratchet system still holds the wheel in place.
Looking to replace only the bolt but found out that I've obviously got to replace the whole skewer to the tune of £28.00 from ChainReaction.
Must admit despite them holding the wheel tighter than my old man's wallet, I've never really got on with 'em. Has anyone any recommendations?
Or whilst I'm there should I just shell out for the thru-bolt ones at £43.99?
The lever then fell off but the ratchet system still holds the wheel in place.
Looking to replace only the bolt but found out that I've obviously got to replace the whole skewer to the tune of £28.00 from ChainReaction.
Must admit despite them holding the wheel tighter than my old man's wallet, I've never really got on with 'em. Has anyone any recommendations?
Or whilst I'm there should I just shell out for the thru-bolt ones at £43.99?
2012 Santa Cruz Highball Carbon 19 lbs
2009 Ibis Tranny __ lbs
2009 Ibis Tranny __ lbs
0
Comments
-
what bolt through ones?"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
DT Swiss RWS Thru Bolts2012 Santa Cruz Highball Carbon 19 lbs
2009 Ibis Tranny __ lbs0 -
Mmm so if your hub has a hollow axle for a QR is it removable without the bearings falling out?
if yes then the thru axles might work. If not then i have no idea how they would work."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
Mmm... indeed!
I was under the impression that you could get conversion kits...???2012 Santa Cruz Highball Carbon 19 lbs
2009 Ibis Tranny __ lbs0 -
depends on the hubs.
and spesh have the only 9mm through front hub that i know off. Other than DT.
10mm thru rear hubs are a bit more common but still rare. (Hope/saint)
Personally I would just get some good Shimano Qr levers."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
Thanks.2012 Santa Cruz Highball Carbon 19 lbs
2009 Ibis Tranny __ lbs0 -
As Nick says, it depends on the hubs whether you can get 9mm and 10mm converters or not. Even then it will be expensive. A DT RWS set will total 90-100 quid.0