Disk Brakes and Mounts.
The Northern Monkey
Posts: 19,136
I have 160mm RS Domain 318's and am about to buy the new Saint brakes, but what mounts do i need?
I know i can use the 200mm rotors, but i have the option of-
1) post>boxer (i'm thinking not
2) post>IS
3) post>post
Also, on the rear, any ideas what size rotor i could get away with on a HT (NS Surge) and again what mount i'll need?
Thanks
B
I know i can use the 200mm rotors, but i have the option of-
1) post>boxer (i'm thinking not
2) post>IS
3) post>post
Also, on the rear, any ideas what size rotor i could get away with on a HT (NS Surge) and again what mount i'll need?
Thanks
B
0
Comments
-
About the front it should be Post to post, Domains are post mount and most brake calipers are post mount. By the pictures I'm 90% sure you'll need post to post.
Others to confirm this?
Rear: for 185mm there should be enough room (160 looks small, 203 bit stupid imo, 185 spot on)0 -
ok kewl.
Yea i want 180mm on the rear but i think the adapter is o.o.s.
Want to buy them asap, before the price increases 0 -
looked on RS's webby? it tells you."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
nicklouse wrote:looked on RS's webby? it tells you.
yes it says post mount. but..post>post? post>IS?...0 -
so what are your brakes mounts?
http://www.bikeradar.com/forum/viewtopic.php?t=1590919
have a read, and then add an adaptor for disc size you want."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
At the rear I think all (most) frames are IS mount and the caliper woud be post mount.
So you'll need post to IS.
Like this one, I think.
http://www.chainreactioncycles.com/Mode ... elID=173030
