kona dawg 06 bushings

lugsey2k5
lugsey2k5 Posts: 960
edited January 2009 in MTB workshop & tech
hello
i recently noticed the bottom swing arm bushing has become warn and has a small amount of play in it. iv been looking the kit to fix it and only found these two so far

http://www.chainreactioncycles.com/Mode ... elID=22608

http://www.chainreactioncycles.com/Mode ... elID=22606

the first one looks right but it says on there for the xc range but mine are the bk.
does any one know if these would fit as they are rather cheap
if not does any one have the specifications for them, i.e the dimentions and material
thanks

Comments

  • stumpyjon
    stumpyjon Posts: 4,069
    If in doubt get the bike to a Kona dealer to get them to spec the right bushings. Might be more expensive but not as expensive as putting the wrong ones in and damaging something.
    It's easier to ask for forgiveness than for permission.

    I've bought a new bike....ouch - result
    Can I buy a new bike?...No - no result
  • lugsey2k5
    lugsey2k5 Posts: 960
    cheers think i read three was one not too far from here. and just took the whole back end off and part. the bottom bushing behind the crank was well seized had to bring out mr hammer.
    there was a fair bit of play in the bearings was thinking about machining a bushing myself but since its the bearings ill have to buy them
    thanks

Categories