Pad rub on new EBC pads
ramonzarate
Posts: 122
as above replaced the pads on my bike with new EBC sintered pads.
front brake works fine no rub nice and tight lots of grip.
rear is rubbin a bit with a metal type squeal,not loads but enought to annoy me.
will this disappear as they bed in or is there any slight adjustments i could make to eliminate this? ideally i dont want to bleed the brakes as they feel pretty good.
just a tiny amount should do.
Shimano XT 765 by the way.
front brake works fine no rub nice and tight lots of grip.
rear is rubbin a bit with a metal type squeal,not loads but enought to annoy me.
will this disappear as they bed in or is there any slight adjustments i could make to eliminate this? ideally i dont want to bleed the brakes as they feel pretty good.
just a tiny amount should do.
Shimano XT 765 by the way.
0
Comments
-
they need to bed in.
did the brakes need bleeding before the pad change? No. then they do not need a bleed now.
you may be did not push the pistons home the same on the rear.
if they have not settled after a few rides reset and align caliper (if needed)."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0
