powder coating

beastinla

if i get my cranks and forks sand blasted and then powder coated will all of the paint rub off or chip off

will be done by body work shop

baccaman21

I'd imagine so yes.

Anodizing may be a better option?

beastinla

why do you think it will rub off i thought it would be ok because people have there frames done and they are ok

nicklouse

anything will come off if rubbed enough.

Marjory Stewart BAxtor

nicklouse wrote:

anything will come off if rubbed enough.

*snigger*

beastinla

ya i no that but i will be ok on forks i thought because nothing rubs on them but it was cranks i was not shore about

supersonic

Also depends how it is applied and prep of part beforehand. A good powder coat for tough conditions when prepped properly should not peel, but as nick says, it will rub through eventually. Best finish for cranks is polished if you want to keep them looking nice.

beastinla

ok thanks guys

Prints

other option for the forks is enamal coating, is a little tougher and not much more expensive i found