DMR V8 Pedels - Bearing Sheald
dhutch
Posts: 343
In a stroke of extravagance i bought a pair of DMR V8's
- However i notice that after a ride, the silver alumium beairng shealds/disks work there way down the shaft to sit against the crank arms.
- There fairly. Would stay there but not if pushed. I was thinking about taking them back, but when i was in the shop all the display ones where the same?
Are they not ment to stay close agasint the pedel/bearing?
Also the instructions say to squirt the supplyed grease in to the grubscrew whole untill it comes out of the bearing.
- I put half the grease into one pedel and saw nothing. I put the rest in the other one for hits and giggles. But yeah, thats a bit poor too?
...Should have got the wellgos?
Daniel
- However i notice that after a ride, the silver alumium beairng shealds/disks work there way down the shaft to sit against the crank arms.
- There fairly. Would stay there but not if pushed. I was thinking about taking them back, but when i was in the shop all the display ones where the same?
Are they not ment to stay close agasint the pedel/bearing?
Also the instructions say to squirt the supplyed grease in to the grubscrew whole untill it comes out of the bearing.
- I put half the grease into one pedel and saw nothing. I put the rest in the other one for hits and giggles. But yeah, thats a bit poor too?
...Should have got the wellgos?
Daniel
0
Comments
-
well wellgo make the DMR and just about thre rest of the worlds pedals."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0
