Tyre advise please

Lateuk

Hello,
I have 2 questions:

- firstly how come i replaced a 2.35 tyre with a different make of 2.35 tyre and the second one rubs the frame when i put a lot of pressure on the pedals but the first didnt?

- secondly i ride a Kona Hoss on canals and dirt/grit paths and grass, i dont want to use 2 different sets of tyres but i do want them to last for a good few hundred miles and have a good amount of grip on dirt and grass hills and of course not to bt too heavy. I am happy to pay up to £40 for a set of tyres. What would you recommend?

Thanks

Late

supersonic

Tyres dont always measure the same for a stated width. Frame flex or torque on the wheel will be causing this rub. Try and make sure the tyre and wheel are installed properly.

Splasher

I'd recommend Maxxis Ignitors 2.1s for your bike/usage http://www.chainreactioncycles.com/Mode ... delID=9880

I'd run a 62a on the front and a 70a on the rear so you've got the best combo of wear and grip.

Lateuk

I have a 2.1 on the front at the moment and it seems a little narrow. Am i right in thinking a wider tyre will give me better grip, be heavier, but will not give the best acceleration and pace?

Thanks

Splasher

You're about right, although you will get a much better increase in grip by choosing the right tyre for the job. Tread pattern and rubber hardness play a much bigger part than carcass size in determining grip levels. Bigger carcasses allow you to run slightly lower pressures and provide more cushioning.