Fitted a catseye wireless unit but not working?

Ruskie

Any ideas why it is not registering? Fitted it as high up on my forks as possible but speed etc, does not register.
Help please!!

jacktheoc

what part have you fitted on your forks ??

Ruskie

jacktheoc wrote:

what part have you fitted on your forks ??

The sensor part, then the screw part to my spoke, as near as possible. As far as i can see it is set up properly, really frustrating me now.

fozy

i have just bought the strada wireless and fitted it tonight and it works fine. sounds like a fault. It was dead easy and worked straight away, take it back!

Ruskie

fozy wrote:

i have just bought the strada wireless and fitted it tonight and it works fine. sounds like a fault. It was dead easy and worked straight away, take it back!

Well going out for a ride tomorrow morning so think i will call at shop where i bought it from ask them to have a look. Still if anyone has any suggestions would be much appreciated.

ddraver

did you take all the plastic covers off the batteries...try undoing them all and making sure they connect properly

Red Panda

I've got a Strada Wireless and it worked straight out of the box, no problems. If I were you I'd retrack my installation steps making sure I'd done everything spot on. Then, if there's no life in it I'd take it back.

BTW, you have got the spoke magnet passing about 5mm from the right part of the transmitter unit?

davydesign

also make sure the sensor on your forks is mounted on the front side of the forks (ie. the side towards the direction you ride in), otherwise the signal can have trouble reaching the bars as the forks kinda block it.

Thats what happened with mine anyway.