Do I Have To Replace My Hub?
segt11
Posts: 14
I noticed my back wheel wasn't running smoothly and was a bit "wobbly". All the bolts were tight so i figured it must be the bearings. Took it apart and the bearings were worn and the bearing tracks were worn and scored as well. There was still loads of grease in there, but i guess some dirt and water must have got in there. I've had a look and it dosent appear that you can replace the bearing tracks - am i wrong and will i need a new hub?
Thanks.
Thanks.
0
Comments
-
Sounds like its had it, and needs to be replaced. Cones and bearings can be replaced, very rarely the inner race can be. Often cheaper to buy just a new wheel. What hub is it?0
-
The hub is a shimano viam - don't think its anything special, just came stock on my GT Ruckus.0
-
Possibly the Shimano RH 475, I have a 2004 Ruckus 3.0. You dont have much to lose by running it into the ground, but its had its day I am afraid, will always be notchy or loose. new rear wheel from merlinfor about 45 quid. To rebuild your old wheel, looking at the hub (25 quid) plus labour (15-20) quid and maybe new spokes too. I'd just get a new wheel!0
-
I've got the 04 model as well. Can you recomend a deacent rear wheel. Thanks.0
-
Cant go wrong with these prices:
http://www.merlincycles.co.uk/acatalog/Disc_Wheels.html
Deore hubs are dependable, but consider XT for longer life and less servicing. XM719 rims would be my choice for trails and harder riding, EN321 for more jumping. So looking at 50 or 60 quid. Check the sale section out for good paired deals. ACI DB spokes are all you need.0 -
I mainly do trail riding and XC, but do jumping as well, so is it worth going for the EN321 anyway? Thanks.0
-
For extra security yes. I actually use the much lighter XM317, but dont do much jumping. However they did take a ding and flat spot on fairly tame terrain, so extra strength is recommended.0
-
Will probably go for those ones then, as i'm not too fussed about weight. Thanks a lot for your help.0
