Identifying hubs ?

FullFatPete
FullFatPete Posts: 4
edited February 2018 in MTB workshop & tech
Hello :D

I have a 2010 GT Avalanche 3.0 in standard trim (its not had any changes or upgrades) and I'm struggling to identify the rear hub so I can order new cones, dust seals and bearings. Is there anywhere I can get this information ? I can't see anything printed/stamped into the hub itself.

Thanks in anticipation

Comments

  • cooldad
    cooldad Posts: 32,599
    Bearings will be balls, so that's easy. 99 % chance 3/16th" front and 1/4" rear. 20 front and 18 rear.

    probably some rebadged Chinese hubs, Formula or Quando or similar. Again probably a common size, so locally Cyclo is available from most places cheap.

    Or just clean and lube the cones you have.
    I don't do smileys.

    There is no secret ingredient - Kung Fu Panda

    London Calling on Facebook

    Parktools
  • FullFatPete
    FullFatPete Posts: 4
    Thanks, bang on with the 1/4 x 18 balls, but I'd like to replace the cones and dust covers as well. I suppose the simple answer is go see my local bike shop !
  • cooldad
    cooldad Posts: 32,599
    Bet they try and sell you new wheels.
    I don't do smileys.

    There is no secret ingredient - Kung Fu Panda

    London Calling on Facebook

    Parktools
  • FullFatPete
    FullFatPete Posts: 4
    They can try !
  • lpretro1
    lpretro1 Posts: 237
    Most decent LBS will have a second-hand box full of cones, dust caps etc - they should find ones to match

Categories