Lubing suspension fork

IDave
IDave Posts: 223
edited June 2014 in MTB beginners
What do you guys use to lube the stanchions on your fork?

Is it ok to use Green Finish Line?

Comments

  • cooldad
    cooldad Posts: 32,599
    I use Fox Float Fluid.
    I don't do smileys.

    There is no secret ingredient - Kung Fu Panda

    London Calling on Facebook

    Parktools
  • nicklouse
    nicklouse Posts: 50,675
    The best lube to use is the oil or whatever is the lube in the fork.

    Chain lube can be used as well.

    Don't use aerosols.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • JBA
    JBA Posts: 2,852
    For the exposed part of the stanchions I use Fork Juice. Seems to work well removing gunk from the tops of the seals and keeping the fork action smooth.
    “Life has been unfaithful
    And it all promised so so much”

    Giant Trance 2 27.5 2016 ¦ Sonder Broken Road 2021¦ Giant Revolt Advanced 2 2019 ¦ Giant Toughtroad SLR 1 2019 ¦ Giant Anthem 3 2015 ¦ Specialized Myka Comp FSR 2009
  • felix.london
    felix.london Posts: 4,067
    yes - I've used green (Wet) Finish Line on fork stanchions and it's fine (but now use Brunox)
    "Why have that extra tooth if you're not using it?" - Brian Lopes

    Votec V.SX Enduro 'Alpine Thug' 2012/2013 build

    Trek Session 8
  • rockmonkeysc
    rockmonkeysc Posts: 14,774
    Whatever you use (all suggestions above are good) only apply a very fine layer and cycle the fork through it's travel a few times.
    Too much lube on the stanchions will attract dirt and cause more damage than it prevents.
  • IDave
    IDave Posts: 223
    Thanks guys, I'll just use Finish Line and wipe off the excess with a (lint free :wink: ) cloth.
  • Fork Juice gets my vote, just a little each ride
  • buddy_club
    buddy_club Posts: 935
    Silicone Lube for me, but thinking when my little bottle runs out im gonna use fork juice, mate put a bit on mine the other day it it was much better.
    Framebuilder
    Handbuilt Steel 29er https://goo.gl/RYSbaa
    Carbon Stumpjumper https://goo.gl/xJNFcv
    Parkwood:http://goo.gl/Gf8xkL
    Ribble Gran Fondo https://goo.gl/ZpTFXz
    Triban:http://goo.gl/v63FBB
  • bluechair84
    bluechair84 Posts: 4,352
    One tip I picked up from a Sram Tech is to use a zip tie to peel back a small gap in the fork seal. Then dribble oil down into the foam rings. Do this in a few spots around the seal. This is preferable to lathering up the stanchion as RC says; it'll just trap dirt. Mr Sram Tech said a chain lube would be fine but obvs the same oil as in the fork would be preferable.