GSC 10 fitting on Specialized Roubaix
Anyone fitted a GSC 10 cadence/speed sensor on a Specialized Roubaix?
I assume you've had to position the speed sensor up rather than down because of spoke clearance. What about the gap between the cadence sensor and the crank arm?
Seen different solutions for other frames in the forum including Neodymium Magnets! Just wondered if anyone had advice specifically for this setup.
Thanks
I assume you've had to position the speed sensor up rather than down because of spoke clearance. What about the gap between the cadence sensor and the crank arm?
Seen different solutions for other frames in the forum including Neodymium Magnets! Just wondered if anyone had advice specifically for this setup.
Thanks
2010 Specialised Sirrus Pro (drop bar conversion)
1993 Specialised Rockhopper A1
Voodoo Limba - for out with the kids
1993 Specialised Rockhopper A1
Voodoo Limba - for out with the kids
0
Comments
-
I have my sensor on top of the chainstay on both my Spesh Allez and Felt Z4 but with the speed arm angled down just in case. For the cadence sensor I use a neowhatsit magnet on the inner end of the pedal spindle. Works a treat.I have only two things to say to that; Bo***cks0
-
I have it on top of the chainstay on my Roubaix, arm downwards. Fits no prob.0
-
Oh, and to answer your second question, magnets from ebay for the end of the pedal spindle - looks much neater anyway. About a fiver for two.0
-
rickwiggans wrote:Oh, and to answer your second question, magnets from ebay for the end of the pedal spindle - looks much neater anyway. About a fiver for two.
Sounds interesting, got a link?0 -
Search ebay for garmin magnets. Loads come up.0
-
rickwiggans wrote:Search ebay for garmin magnets. Loads come up.
Found them, nice, thanks.0 -
