Rockshox dual air - quick question.

denis's mate
denis's mate Posts: 88
edited August 2013 in MTB workshop & tech
Just had my Rockshox dual air Rev 426 serviced. New seal everywhere.
Now, I'm sure when both + and - chambers are the same pressure, all the stanchion will be visible, ie max travel. Am I correct cos mine now only show 110mm when the travel is nominally 130mm and both + and - chambers are at 100psi.

Comments

  • Jay76
    Jay76 Posts: 58
    I have 426 RLV's and mine are the same. Havent had them serviced mind.
    **2011 Cove Stiffee**
  • denis's mate
    denis's mate Posts: 88
    Jay76 wrote:
    I have 426 RLV's and mine are the same. Havent had them serviced mind.
    It appeared I put the fork lowers back with the damper compressed. This means the fork needed "burping".
    Remove the valve cores, compress then extend the fork. With the fork fully extended refit the valve cores and pump up the desired pressure. You then should have full travel. Worth 10 mins of your time.

Categories