Who sell this tool

The two sellers are one and the same; "Jerade" is his BR username too.

I bought a bearing press from him a few months ago and will vouch for his professionalism and integrity. He's a true old-school gentleman and went the extra mile to get my custom order right.

I've not had the chance to use the press due to postponing (abandoning) the project but the tool's workmanship is top notch. I figured why pay a shop to do it once when I can buy the tool for the same price?

gavbarron wrote:

Or make one, it's only some stud bar, a few washers and nuts

+1... I've made a few tools of that nature(headset press, wheel stressing press).

Bikeit65 wrote:

could you give me some more info please and a photo of the press tool

Who or whom are you wanting to see pictures from?

Bikeit65 wrote:

Dennisn

I'll give it a try tomorrow, but I am somewhat technically inept, so don't hold your breath.

Bikeit65 wrote:

Dennisn

Here's a shot of my "sort of" homemade headset press. It's a 1/2" fine thread, all thread rod with a couple of heavy washers, 2 thrust bearings(not really necessary, but nice), 2 oilite bushing(brass colored things), and a couple of heavy nuts. The oilite bushings were made by my uncle, a machinist, and even they aren't a requirement. This most likely could also be used be used as a bottom bracket press in tool although I don't use the press in kind.