Got a new frame today and the headtube is markedly shorter than my old setup. As I'm hoping to transfer the old fork over and don't want to much of a stack, how can I cut the steerer, bearing in mind there's already a star nut in there...
why the hell would you bash one starnut down the steerer then fit another one???
just put a philips screwdriver in the screw hole of the starnut and hammer slightly until it is 1cm below the intended cut line. then just use a hacksaw and line it up straight. I did this five minutes ago which was ironic. I don't understand why you would compromise riding position for a spacer free cockpit though?