Campag Veloce

skyblueamateur
skyblueamateur Posts: 1,498
edited June 2012 in Workshop
When in a low gear the chain seems to be catching the front derailleur guide. Anyone any idea's what this could be/a quick fix? Thanks

Comments

  • 16mm
    16mm Posts: 545
    If it used to work OK, and you haven't fiddled with anything, it coiuld be
    that instead of resting on the screw that restricts the inward movement, the mech was 'held' by cable tension, and the cable has stretched, allowing the mech to move inwards.

    If so, use the cable adjuster on the frame to tighten the cable. Do this when the cable is slack, eg chain on big ring, but shifter on small, and re test.
  • cycleclinic
    cycleclinic Posts: 6,865
    It nothing speific to campag veloce. You ust need to setup your front mech.

    Remove cable and set limit screws so there is no rub then anhor the cable so it is taught and ride.
    http://www.thecycleclinic.co.uk -wheel building and other stuff.
  • g00se
    g00se Posts: 2,221
    thecycleclinic wrote:
    It nothing speific to campag veloce. You ust need to setup your front mech.

    Remove cable and set limit screws so there is no rub then anhor the cable so it is taught and ride.

    +1 - Follow the campag instructions to the letter. It's very specific. Start with the alignment of the mech to the frame as it might have slipped. You can download them from their website.

Categories