Frame - GT Avalanche (not sure wich one yet though)
Samsokid
Posts: 2
Hey guys I'm new in mountainbiking and would like to know if anyone can tell me if the parts i found fit eachother and a GT Avalanche frame:
(10 speed shimano xt rear gearing)
http://www.chainreactioncycles.com/Mode ... elID=52281
http://www.chainreactioncycles.com/Mode ... elID=52300
http://www.chainreactioncycles.com/Mode ... elID=52299
http://www.chainreactioncycles.com/Mode ... elID=58726
http://www.chainreactioncycles.com/Mode ... elID=55190
Hoping to get your opinion on the setup too, I got an old diamond back component bike, where I'm going to take the parts, I'm missing from.[/u][/i]
(10 speed shimano xt rear gearing)
http://www.chainreactioncycles.com/Mode ... elID=52281
http://www.chainreactioncycles.com/Mode ... elID=52300
http://www.chainreactioncycles.com/Mode ... elID=52299
http://www.chainreactioncycles.com/Mode ... elID=58726
http://www.chainreactioncycles.com/Mode ... elID=55190
Hoping to get your opinion on the setup too, I got an old diamond back component bike, where I'm going to take the parts, I'm missing from.[/u][/i]
0
Comments
-
Yes, That would all be fine. I think this should be in the Buying Advice section though.
Secondly if your new, why dont you just buy a pre-built Avalanche n test your skills first, then upgrade as you go along?
Pauls cycles have great deals on GT Avalanches.
http://www.paulscycles.co.uk/products.p ... 1b1s2p2458
^^^ ^^^ ^^^ ^^^ ^^^
2010 GT Avalanche 1.0, All the kit is great for a beginner, It is 9 speed though.0 -
The chain device won't work because you don't ISCG05 mounts on the frame you'd need a BB mounted version. I assume you plan to run a single ring.0
