Cant this be faced?

Graydawg
Graydawg Posts: 673
edited April 2010 in MTB workshop & tech
Ok so following my previous post last night I think I'm going to upgrade my crankset to Hollowtech II from the current Octalink internal Bottom Bracket setup.

However I will need to get my BB Shell faced by the LBS. They say they can do it for around 15-20 quid but I just inspected the shell face and seen this dent.. Can this be machined out ok? Current setup with the internal BB is fine as it doesnt affect that, however I am not sure on the suface for Hollowtech II?

Pics below.

Thanks!

DSCF1502.jpg

DSCF1498.jpg
It's been a while...

Comments

  • nicklouse
    nicklouse Posts: 50,675
    no probs.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • Graydawg
    Graydawg Posts: 673
    Nicklouse, you are an absolute legend! Fast and Always reliable with the replies. Thank you! :);)
    It's been a while...

Categories