Reba WC forks wiggle inside steerer tube w/ Hope on Epic frm

Brocade · February 2010

Folks,

I may as well post a last ditch question here to see if someone can give me any advice on this issue as I am about to give up. I've been trying to build a Specialized Epic 2008 bike with Reba Rockshox World Cup forks. The forks came with the steerer nut installed but no headset so I went out and bought a Hope Threadless headset.

The problem I have is that the fork wiggles near the lower head tube race (using the terminology in Wikipedia here as a reference http://en.wikipedia.org/wiki/Headset_(bicycle_part)#Threadless_headsets It feels like the lower head tube race does not really slot tightly into the steerer tube at the bottom. The upper head-tube race fits like a glove. I have all the parts fitted as in the Wikipedia reference picture.

Any recommendations ?

Thanks in advance.

Chunkers1980 · February 2010

Park terminology would be best.

Got any pics?

Sounds like the race is not seated properly or the bearings are not set correctly/upside down

bomberesque · February 2010

you set the crown race (the bottom component in the picture on your link) onto the steerer at the crown yes? that needs a tool (read; correctly sized tube) to get it properly seated, sometimes you have to hit it pretty hard to get it on right it's a tight fit

as Chunkers says, pics please, especially of the steerer/crown/crownrace assembly

nicklouse · February 2010

lose headset is either parts missing/incorrectly assembled or top cap bottoming out on the top of the steerer.

which Hope headset is it. with the split crown race or the earlier one with all the O rings?

Reba WC forks wiggle inside steerer tube w/ Hope on Epic frm

Posts