headset spacers
I was trying to get a slightly lower setup on my bike so removed a couple of spacers from underneath my stem. However, even If i remove one of these spacers, when I screw the headset bolt back there is a lot of movement from the headset and fork. If I put the spacer back in, the headset and forks are tight again...
What am I missing...? :oops:
Cheers
Colin
What am I missing...? :oops:
Cheers
Colin
0
Comments
-
move the spacer from below to above the stem and reassemble0
-
put the spacer above the stem and re-tighten0
-
move the spacer from below to above the stem and reassemble0
-
you need to put the spacers back on top of the steerer.
then you will be able to set the headset peload."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
ah! thanks a lot
Cheers
Colin0 -
sorted! all back together and reloaded! i'll probably have a sore back for a few weeks now..?0