Headset and forks!

GaryGkn
GaryGkn Posts: 1,199
edited November 2008 in Road general
I can't seem to adjust the headset on an old Falcon.
If I lock down the lock nut tightly the forks are tight on the right turn.
Does this mean they may be bent very slightly?
Brakes are centre pull and the cable guide gets in the way of me keeping the one headset spanner in place or it gets locked down and sandwiched into the headset I was thinking of trying again with a washer allowing me access to the bottom nut? :(

Comments

  • Monty Dog
    Monty Dog Posts: 20,614
    Could be a couple of things: headtube not faced squarely, headset cups not fitted squarely, bent fork steerer or most likely, the thread on the fork steerers isn't cut square. Remove the forks and screw on the top race and check if it is square to the steerer - put a spot of marker pen on the outside and see if it moves off square as you turn it.
    Make mine an Italian, with Campagnolo on the side..
  • GaryGkn
    GaryGkn Posts: 1,199
    you were right it looks to me that the crown race is not on square possibly because the column is out and making it look that way. Pain in the bum!