Planet x nanolight headest installation

bratman
bratman Posts: 5
edited May 2012 in Workshop
I recently purchased a px nanolight frame with the px headset and bung included. The headset does not come with any instructions and while I feel pretty comfortable about installing it I would like to be sure about what goes where since there are two different washers. If anyone has any detailed drawings, pictures or instructions I would appreciate it.

Comments

  • amaferanga
    amaferanga Posts: 6,789
    Both spacers go above the top bearing. If it's like mine there's a thin washer and a split washer. Mine goes bearing - thin washer - split washer. Dunno if it's right, but that's how it came from P-X and it's been fine.

    Btw when you come to need new bearings, the RIbble Stealth uses the same bearings (and they're actually available to buy, unlike replacement bearings from P-X for the Nanolight).
    More problems but still living....
  • bratman
    bratman Posts: 5
    Thanks for the reply. I will do the same.
  • bratman
    bratman Posts: 5
    actually, it would seem to be the opposite. The split ring fits in the top bearing pretty neatly. the thin washer would prevent that. I installed the split and then the thin and i will see how it goes.
  • bratman
    bratman Posts: 5
    wow. You needed to create an account just to post that? you know you can just ignore something and move on with your life?

Categories