Campag 11-speed set up tutorial

cubicboy
cubicboy Posts: 117
edited August 2011 in Workshop
So, I've built my bike up, and I now need to set the gears up properly.
Can anybody point me in the direction of perhaps an online tutorial or website.
All cables are routed correctly and fastidiously, but I've never done this before.

ta.

Comments

  • rafletcher
    rafletcher Posts: 1,235
    Just go and download the technical literature from the camapg website. The fact that it's 11 spedd, not 10 or 9 should make very little difference.

    Or you could lok at the park Tools workshop tutorials.
  • arlowood
    arlowood Posts: 2,561
    Plenty of vids on YouTube.

    None specifically for Campag as far as I can see but the principals will be the same whatever groupset you have. Just make sure you know which limit screw is which and you should have no problem.

    Try this one to begin with:-

    http://www.youtube.com/watch?v=UhmfBVkR9e0

    But this one is also good but tackles the issue in a slightly different way.

    http://www.youtube.com/watch?v=SkzvfCaI ... re=related

    Just browse around and you will find all you need. - Good luck
  • on-yer-bike
    on-yer-bike Posts: 2,974
    Make sure the rear mech hangar is aligned properly before you start. Dont assume that because its all new that it will be. Once you have the limit screws set which you should do before attaching the cable its just a case of having the correct tension in the cable. You may need to slightly fine tune the lower limit screw at the end.
    Pegoretti
    Colnago
    Cervelo
    Campagnolo

Categories