FOX TALAS Forks
ew77
Posts: 57
Hi guys
Bit of a numpty question I suspect, but I assume that when you adjust the travel of the TALAS forks, the geometry of the bike changes slightly?
I.E. when you hit a climb, you adjust the fork down to the lowest travel setting, and the geometry changes slightly to lower the front end to assist you with the climb? And then when you go to go back downhill you adjust back up to full travel and the bars raise back up for a better position?
The above is what happens on a set of Manitou Blacks I have with RTWD, but wanted to make sure it was the same for the TALAS forks, and not just the amount of travel that changes but at the same geometry (if you get what I mean?!)
Sorry for the stupid question!
Bit of a numpty question I suspect, but I assume that when you adjust the travel of the TALAS forks, the geometry of the bike changes slightly?
I.E. when you hit a climb, you adjust the fork down to the lowest travel setting, and the geometry changes slightly to lower the front end to assist you with the climb? And then when you go to go back downhill you adjust back up to full travel and the bars raise back up for a better position?
The above is what happens on a set of Manitou Blacks I have with RTWD, but wanted to make sure it was the same for the TALAS forks, and not just the amount of travel that changes but at the same geometry (if you get what I mean?!)
Sorry for the stupid question!
0
Comments
-
-
Thanks Neily030
