helicoiling
tim_wand
Posts: 2,552
I fancy having a go at repairing the thread on my On One In Bred rear mech hanger.
I figure the Bolts M8 but I dont know the pitch. Does any one have any experience of doing this and Know the Thread size and Pitch for the insert.
Also any one know of a good supplier of a cheap kit and what else I will need.
Drill bit. Insert tool. Tang cutter etc
please help or anyone know a decent light engineering company in Newark Notts
I figure the Bolts M8 but I dont know the pitch. Does any one have any experience of doing this and Know the Thread size and Pitch for the insert.
Also any one know of a good supplier of a cheap kit and what else I will need.
Drill bit. Insert tool. Tang cutter etc
please help or anyone know a decent light engineering company in Newark Notts
0
Comments
-
http://www.engineering-supplies.com/pro ... ltap-tang/
Brought a simular kit years ago but not from these people. Normal thread for M8 is 1.25 but M8 x1.00 is also available and you can check by measuring the pitch across the tops of the thread.
AndyAndy
Cube Acid
Specialised Allez
Raleigh Flyer, from along time ago....................0 -
Best of emailing OnOne, they will have all the mechanical details you need.0
-
Super Sonic / Andy 525 thanks for that . Will give On One a ring once I ve seen CAV crying after taking another stage (hopefully)0
-
Victory for CAV. and a result for me at ON ONE . Stevo their tech guys put me straignt its a M10 with 1.00 diameter and 1.00 Pitch.
Cheers
0 -
I was about to say its M10x1.00 0
