Is my XT front Mech set up correctly ?? Photos

afcbian
afcbian Posts: 424
edited May 2010 in MTB workshop & tech
I have just fitted an M771 XT front Mech to my Giant.
It works fine but the cable routing looks weird as it comes out of the cable stop and then goes at an angle down to the side pull mech
Is it done correctly ??
Photos here http://www.flickr.com/photos/47060994@N ... otostream/
I think it is a top pull low normal
Any comments welcome
I ride therefore I am

Comments

  • Anonymous
    Anonymous Posts: 79,666
    looks fine to me.
  • afcbian
    afcbian Posts: 424
    looks fine to me.

    Thanks.
    Wasn't sue about the cable angle. Expected it to go vertically.
    Always nice to be reassured.
    I ride therefore I am
  • Anonymous
    Anonymous Posts: 79,666
    i have seen the exact same set up in a few builds, my on one was also the same,as was my orange. does look odd but works fine.
  • afcbian
    afcbian Posts: 424
    It was also to do with where to route the trailing end of the gear cable
    I ride therefore I am
  • allthegearnoidea
    allthegearnoidea Posts: 4,077
    yup, is the same as mine, looks very odd but is how it is, the tail end of my cable runs down, under and up the black arm bitand is cable tied inplace on the end of the arm, (opposite to where it clamps) and there's just enough to poke the end into the slot on the clamp,
    Timmo.
    After all, I am Cornish!
    http://cornwallmtb.kk5.org/
    Cotic Soul, The bike of Legends!:wink: Yes, I Am a bike tart!
    http://www.bikeradar.com/forums/viewtop ... 1#16297481
  • The Rookie
    The Rookie Posts: 27,812
    Some frames have the cable stop inclined so the cable exits neatly from it, but what you have their is perfectly normal.

    Simon
    Currently riding a Whyte T130C, X0 drivetrain, Magura Trail brakes converted to mixed wheel size (homebuilt wheels) with 140mm Fox 34 Rhythm and RP23 suspension. 12.2Kg.