Bleedin Tektro Auriga Comp brakes
Seamus 128
Posts: 16
Hi guys having some problems bleeding my brakes as above, Bike is a 08 GT avalanche 1, had a trawl through the forum and on the interweb and found this link
http://www.youtube.com/watch?v=6mg6NbIjmOM
Followed it to the latter but both brake levers can still be squeezed to the handle bars with no resistance.
Am I barking up the wrong tree following this guide for my brakes?
Both brakes worked fine until I replaced the brake pads, so I'm assuming air has got into the brake lines when i split the calipers?
Any help or advise will be greatly appreciated
http://www.youtube.com/watch?v=6mg6NbIjmOM
Followed it to the latter but both brake levers can still be squeezed to the handle bars with no resistance.
Am I barking up the wrong tree following this guide for my brakes?
Both brakes worked fine until I replaced the brake pads, so I'm assuming air has got into the brake lines when i split the calipers?
Any help or advise will be greatly appreciated
0
Comments
-
point 1 there is no need to split the callipers to change the pads.
point 2 why follow instructions for a different make and type of brake?
yes there will be air in the system.
what fluid did you use?"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
oh and there is a link in the teck link sticky above to the tektro site where you can download the bleeding info.
http://www.tektro.com/04support/pdf/Auriga-English.pdf"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
point 1 Doh! did,nt realise! every days a school day!
point 2 because i'm a numpty.
Cheers nick, will now have another go with the correct instructions0