Why wont my front mech change into the outer ring?
Dannyleigh
Posts: 32
I have this mech;
http://www.chainreactioncycles.com/Mode ... elID=40546
And this crankset;
http://www.chainreactioncycles.com/Mode ... elID=25146
My BB shell is 73mm and I have done what it says on the Parktool website (1 spacer on the driveside, none on the non drive-side.) For some reason the front mech can't physically reach the outer ring, even if I pull it.
Does anyone know what may be going wrong?
Thanks,
Dan.
http://www.chainreactioncycles.com/Mode ... elID=40546
And this crankset;
http://www.chainreactioncycles.com/Mode ... elID=25146
My BB shell is 73mm and I have done what it says on the Parktool website (1 spacer on the driveside, none on the non drive-side.) For some reason the front mech can't physically reach the outer ring, even if I pull it.
Does anyone know what may be going wrong?
Thanks,
Dan.
0
Comments
-
Have you adjusted the limit screw?Now where's that "Get Out of Crash Free Card"0
-
sounds like the limit screw.
find the screw with "h" next to it and un wind it a quarter turn at a time until you can shift into the big ring, be careful not to unwind it too far as you will keep popping the chain off the cranks.0 -
Limit screwIt's easier to ask for forgiveness than for permission.
I've bought a new bike....ouch - result
Can I buy a new bike?...No - no result0 -
Try a screw, then pull it, and you should get it in the big ring.0