Rear mech hangers - which one?
ricktabor1
Posts: 272
Hi,
I've got a Kona cindercone 2008, the rear mech hanger is goosed and i need a new one. Is there a guide/chart to find out what model of hanger to buy?
Can anyone help?
I could go to my LBS but i was thinking that i might be able to get one off the internet cheaper if I could work out what i needed.
YES I'M A TIGHT GIT
I've got a Kona cindercone 2008, the rear mech hanger is goosed and i need a new one. Is there a guide/chart to find out what model of hanger to buy?
Can anyone help?
I could go to my LBS but i was thinking that i might be able to get one off the internet cheaper if I could work out what i needed.
YES I'M A TIGHT GIT
Got to get up to get down
0
Comments
-
"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
That's some list on the BETD website.
Cheers for that.Got to get up to get down0 -
look on the link nick posted in the shop section, they are about a tenner through the kona shop!!
i got a couple from there for my old bike (always carry a spare!) good delivery seing as it comes from italy or something like that!!
*edit*
heres the link to the hangers!
https://shop.konaworld.com/eu/products. ... ur-Hangers
just checked as am in helpfull mood today and looks like you have a H hanger, in which case, this is where i got my other spare from for the old bike,
HereTimmo.
After all, I am Cornish!
http://cornwallmtb.kk5.org/
Cotic Soul, The bike of Legends! Yes, I Am a bike tart!
http://www.bikeradar.com/forums/viewtop ... 1#162974810 -
Cheers Timmo - you are literally the most helpful person ever.
I've bought one - job done.Got to get up to get down0 -
Just a bit of advice in case you go down the path of BETD (I think that's what they're called).
I bought one for my old Bianchi ML3 and it's certainly looks better quality and is more sturdy than the original but I had to take a file to it to get it to fit nicely into the dropout. It wasn't a biggie but the mount hole and dropout were about a mm off and there was no way it would fit without taking some material off the back (curved) edge. Use a fine file and take it a bit at a time if yours is the same0