Hub bearings

rhann
rhann Posts: 383
edited August 2009 in MTB buying advice
Wheres the best place to get hub bearings for are they hub dependent or generic.

Comments

  • nicklouse
    nicklouse Posts: 50,673
    what hubs?

    normally generic size and most LBS's have piles of them.

    Most front hubs use 10 3/16" balls on each side; Most rear hubs use 9 1/4" balls on each side.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • rhann
    rhann Posts: 383
    edited August 2009
    theres 7 in a cage. and its a front hub. Hubs are unbranded.
  • nicklouse
    nicklouse Posts: 50,673
    again your LBS

    http://www.weldtite.co.uk/productdetail ... cages.aspx
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • rhann
    rhann Posts: 383
    ok thanks for that, was going to look around tomorrow, was hoping there may be somewhere on tinternet, but I guess its best to get them when you can see them and compare e.t.c.

Categories