Shimano Dura Ace Brakes

Carlito123
Posts: 4
Hi,
I am trying to get my rear Shimano Dura Ace brakes to work again.
I have fully taken them apart (except for the one small bit).
What they don't seem to want to do is snap back into neutral after the brake has been used. Any suggestions much appreciated.
I am quite a novice at bike maintenance.
Thanks
K
I am trying to get my rear Shimano Dura Ace brakes to work again.
I have fully taken them apart (except for the one small bit).
What they don't seem to want to do is snap back into neutral after the brake has been used. Any suggestions much appreciated.
I am quite a novice at bike maintenance.
Thanks
K
0
Comments
-
Is this without the cables on ?0
-
did they work before you took them apart..?0
-
cougie wrote:Is this without the cables on ?
with cables0 -
softlad wrote:did they work before you took them apart..?
no this was part of the reason for taking them apart.
Took them apart, gave them a good clean and put them back together.
The brake itself works. As in it pulls but then does not release.
Which is a step forward as pulling wasn't possible either.
It appears to me that it is something simple that is stopping it from releasing back to neutral but not sure what.
Would seem a bit of a waste to go out and buy a new set.0 -
Disconnect the cables - sounds to me like its those sticking ?0