Is is possible?

jimbo-norco
jimbo-norco Posts: 333
edited January 2008 in MTB general
Is it possible to get a new steerer tube for suspension?? ive just been given a set of Psylos for my new build,but its been cut down to fit a curtis bike and only just reaches through the frame of my 24seven. they fit, but i'd rather be on the safe side and fit a new one if possible!
any ideas? obviously it would be a LBS job lol!
thanks!

Comments

  • Splasher
    Splasher Posts: 1,528
    I doubt an LBS could do it. I know Windwave can replace steerers in proper (not OE) Marzocchis so perhaps Fisher can do the same in Rockshox.
    "Internet Forums - an amazing world where outright falsehoods become cyber-facts with a few witty key taps and a carefully placed emoticon."
  • jimbo-norco
    jimbo-norco Posts: 333
    cool thanks!
  • skyliner
    skyliner Posts: 613
    They're a peice of piss to fit, but they may not be available anymore (30mm stanchions on some models), and could cost you as much as £120 - £150 for the CSU (crown and steerer unit).
    It's nice to be important, but it's more important to be nice.
  • dave_s
    dave_s Posts: 4,362
    You could risk one of these
    http://www.chainreactioncycles.com/Mode ... delID=3970

    Although I think it's safer to swop steerer if you can.
    I got a steerer swopped by Windwave on some Marzocchi Z1 FR1s but not sure if it's poss on Rockshox but worth a try.
    Dave S

Categories